RobotShop Feeds

In This Issue...

In this chapter of our Litter-Robot II Repair Guide, we will help you replace the power jack on your Litter-Robot II.

You can find our Litter-Robot II troubleshooting guides here:

You can refer to our advanced troubleshooting guide to help you open up your Litter-Robot II.

Replacing the Litter-Robot II power jack

To replace the power jack, you need a cutter and pliers.

First, locate the power jack on the Litter-Robot base.

Locate the Power Jack on the Litter-Robot Base

Hold the power jack inside the base while removing the nut with the pliers.

Remove the Power Jack Nut with the Pliers

Uninstalled Power Jack

Using the cutter, cut the old power jack from the Litter-Robot harness.

Cut the Power Jack from the Litter-Robot Harness

Connect the power jack white wire to the Litter-Robot harness white wire using the wire connectors.

Pair Wires from the New Power Jack to the Litter-Robot Harness

Slide Both White Wires in the Connector and Crimp Them Using Pliers

Close the White Wires Connector

Repeat the same procedure for the black wire.

Repeat the Same Steps for the Black Wires

Install the new power jack to the Litter-Robot base.

Install the New Power Jack on the Litter-Robot Base

You are Done!